На нашем веб-сайте используются файлы cookie для персонализации контента, содержания содержимого в корзине покупок и в рамках проверки.
Ваша личная информация будет сохранена и передана в виде зашифрованных данных.
У вас есть возможность обновлять и удалять вашу личную информацию.
You consent to our cookies if you continue to use this website.
Разрешить куки для
Necessary Cookies Необходимые файлы cookie не могут быть отключены, потому что они необходимы для правильного функционирования нашего веб-сайта. Они хранят ваш язык, валюту, корзину покупок и учетные данные для входа.
Файлы cookie для Google Analytics Мы используем google.com analytics и bing.com для мониторинга использования сайта и статистики страниц, чтобы помочь нам улучшить наш сайт. Вы можете включить или выключить это с помощью меток, указанных выше.
Маркетинговые куки Маркетинг Cookies отслеживает личные данные. Google и Bing отслеживают ваши просмотры страниц и покупки для использования в рекламе и ремаркетинге на других сайтах. Вы можете включить или выключить это с помощью меток, указанных выше.
Социальные куки Эти сторонние Cookies отслеживают личные данные. Это позволяет интегрировать Facebook, Twitter и Pinterest. например. показывает кнопку Facebook «LIKE». Тем не менее, они смогут просмотреть, что вы делаете на нашем веб-сайте. Вы можете включить или выключить это с помощью меток, указанных выше.
Posted: Hiyas.. Constructing my first set of poi fire wicks. I have the needed 2" Kevlar wicking and basic construction technique down, catherdral, accordian etc..
Before I proceed and drills holes and such, I had a few q's....
I read that Elmers Glue should be applied to the ends/edges, etc. What does this entail, or is it as specific as i typed it? Where does the glue go and how should I apply it?
Tucking the ends in. What's the best way to lock the ends in?? Tuck it in the side?
Washer size on bottom and top. Will larger washers effect the flame size since I'll be reducing wick surface area? Should I just put a large one (1 1/4") on the bottom and a smaller on the top??
I was going to bolt the wick together with a eyebolt ran through the center? Is this adequate or should I use a wire loop dealy?
Any help appreciated! Point me in the right direction before the hardware store see's my face again..
Fireflyer....
adamricepoo-bah 1,015 posts Location: Austin TX USA
Posted: I've posted my recipes online. I think they answer most of your questions.
Laugh while you can, monkey-boy
CharlesBRONZE Member Corporate Circus Arts Entertainer 3,989 posts Location: Auckland, New Zealand
Posted: I would also recommend using PVA on the wick directing underneath where you are drilling. This will make it easier to drill and less likely to start fraying around the washer (which is unlikely anyway, but dangerous if left too long).
Essentially, you are just hardening the outside point-of-contact of the wick...
HoP Posting Guidelines * Is it the Truth? * Is it Fair to all concerned? * Will it build Goodwill and Better Friendships? * Will it be Beneficial to all concerned?